To locate your license version issue the following command whilst in enable mode. See the show local-host command to view host limits. In transparent mode, the interface with the lowest number of hosts is counted towards the host limit. If there is no default route, hosts on all interfaces are counted toward the limit. The interface associated with the default route is considered to be the outside Internet interface. Hosts that initiate traffic between Business and Home are also not counted towards the limit.

Note that even when the outside initiates a connection to the inside, outside hosts are not counted towards the limit only the inside hosts count. I've been able to set up a nat rule to route all requests to one of the public addresses to server1 with a private address 10.22.33.5. The inside ip's are obviously private and the outside ip's are public.

However, I don't see anything in my show run to indicate that the no shutdown statement is saved anywhere (doing a diff before and after proves it too).In routed mode, hosts on the inside (Business and Home VLANs) count towards the limit when they communicate with the outside (Internet VLAN), including when the inside initiates a connection to the outside as well as when the outside initiates a connection to the inside. We have an ASA 5505 with an inside interface 10.22.33.0/24 and outside x.x.x.x/26. Ok, if at some point I run no shutdown on the interfaces and then copy run startup, subsequent reloads seem to bring the interface. One thing that's kind of odd is that even if I run switchport access vlan 1 under int e0/1, it never seems to save that and always leaves it empty. Here's the interface portion of my config: interface Vlan1 In the ASAv console, view cisco asav license keygen note the serial number by entering the FileName: Cisco Asa 5505 License Hack FileSize: 5. Kind of freaked out to deploy this thing somewhere for fear that the interfaces won't come up after a reboot. The Cisco ASA 5505 delivers high-performance firewall, SSL and IPsec VPN, and rich networking services in a modular, 'plug-and-play' appliance. Reboots, configs all there, but interfaces are down. I then ran copy run startup followed by reload. At the prompt hit no the 'interactive setup', enable then conf t then pasted my config in. FACT:Cisco Adaptive Security Appliance (ASA) 5505 - Security Services Card (SSC)has LEDs to assist in troubleshooting the SSC. Write erase to blow away my config, reload and said no to save changes. For some reason, I have to run no shutdown on each real physical interface to get them to come up after a reload.